Por favor, use este identificador para citar o enlazar este ítem: https://hdl.handle.net/20.500.12104/39245
Título: Adhesion between polypropylene and steel by over moulding
Autor: Sanchez-Soto, M.
Illescas, S.
Abt, T.
Candal, M.V.
Gomez, J.F.
Fecha de publicación: 2011
Resumen: In this work, a hybrid polypropylene (PP)/steel car part (Traverse leg) was created by over moulding. PP was modified with 10%wt. of PP-g-Ma coupling agent. Different surface treatments were applied to the steel determining its influence on adhesion. Best peel strength was reached when the steel was sanded. Etching and shot peened plates showed similar but lower levels of adhesion. In all cases, the application of torch heating was necessary to create a thin layer of iron oxide strongly bonded to the steel and by reaction to the PP-g-Ma. To create adhesion a minimum steel temperature of 120°C was necessary.
URI: http://hdl.handle.net/20.500.12104/39245
http://www.scopus.com/inward/record.url?eid=2-s2.0-84857879360&partnerID=40&md5=7607812e2a7795eba6aa0280d03346cc
Aparece en las colecciones:Producción científica UdeG

Ficheros en este ítem:
No hay ficheros asociados a este ítem.


Los ítems de RIUdeG están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.